• Image 1
Model #: 960-222

Product Description

KCS - Kimber Carry Sight Set, Fixed tritium dot rear sight with Kimber® dovetail cut, w/serrations

U.S. Patent #D447205S. This sight set is the tritium version of the Kimber fixed rear sight, designed to give you maximum visibility in well-lit and low-lit conditions.  

The rear blade is partially serrated and has two green tritium dots on each side of the notch that are 0.076” in diameter, with a thick white outline. The entire sight is wire-EDM cut from a single block of 4140 steel. Distinctive grasping serrations are also wire-EDM cut into the sides of the sight.

Fits all Kimber 1911 autos with factory-supplied fixed sights. This will not fit any Kimber cut with an existing adjustable rear sight.


  • Material: 4140 Chrome Moly Steel
  • Blade Type: Partially serrated with two green tritium dots (0.076” in diameter)
  • Sight Dovetail: Kimber Fixed Rear Sight Cut
  • Dovetail Dimensions: 0.350" (Width) x 65° (Angle) x 0.100" (Depth)

This sight set comes with a matching front sight equipped with a 0.118” wide blade in either flat base or contour base options. Compatible with Novak type front sight dovetail cuts (0.330" x 65 Degree x 0.075") as typically found on both customized and factory 1911 pistols.


  • Material: 4140 Chrome Moly Steel
  • Blade Type: Smooth Green Tritium Dot (0.076" in diameter)
  • Blade Height: 0.160"
  • Blade Width: 0.118"
  • Sight Base: Flat or Contoured
  • Sight Dovetail: Novak Type
  • Dovetail Dimensions: 0.330" (Width) x 65° (Angle) x 0.075" (Depth)




Shadow Image

Warranty Information

Limited Lifetime Warranty

We stand behind our products. All Kensight Sights are covered by a limited lifetime warranty. We guarantee our products against defects in material and construction. This limited lifetime warranty does not extend to normal signs of wear. It does not cover breakage, damage or rust due to misuse, improper maintenance, accidents, loss or theft. The warranty does not extend to damages cause by unauthorized repairs.

Any product we determine to be defective will be repaired or replaced solely at our discretion. To receive warranty repair or replacement, the owner must send the product to be evaluated by KFS Industries Warranty Services located at our Atlanta, Georgia headquarters. In addition to the provisions of this warranty, the owner may also have other rights that can vary by state. No other warranties are implied or expressed other than what is specifically stated here.

Warranty Service

All products returned to KFS Industries for a warranty claim must have prior approval of a KFS Customer Service employee in the form of a Return Material Authorization Number (RMA). The RMA must be displayed on the exterior of the return carton. Merchandise returned without an RMA will be refused. The RMA number assigned will expire 30 days from date of issue. To obtain an RMA, please call the KFS Atlanta, Georgia headquarters at (404) 691-7611.

After you obtain your RMA, Please send your product to:

KFS Industries Inc.
875 Wharton Dr SW
Atlanta, GA 30336

You must pay the shipping and insurance costs to return your product to KFS Industries Inc., and we will pay the shipping charges to return the product to your US address only. All International shipping will be the responsibility of the consumer.

Upon receipt of a returned product, we will verify warranty coverage. If the product is not covered by warranty, KFS Industries Inc. will send you an estimate of the cost to repair your product prior to performing any services not covered. Trijicon installs all the tritium vials on the Kensights. All tritium warranty issues must be sent to Trijicon directly.

Shadow Image

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

Shadow Image